a Steel Box Section Build with SBR20 & Ballscrews Plus a few questions

[grain_r]

Good Morning

Thanks, Jazz I will go for the Hiwins at least I know it will be right then, Thank you, Clive, I will go for 30mm for the Pulley.

thank you very much for your help.

Thanks

Rob

[Clive S]

Good Morning

Thanks, Jazz I will go for the Hiwins at least I know it will be right then, Thank you, Clive, I will go for 30mm for the Pulley.

thank you very much for your help.

Thanks

Rob

Not sure but I think the F length is included in the overall length of the screw so check with Fred or send him a sketch