AT1 Single Phase to Three Phase Penske Spindle Woes....

[Doddy]

If you've not done so already: You may (probably will) need to configure the VFD parameter set. There should be a manual provided (or link to) that describes the parameters, defaults etc, and you'll need to understand how to configure these with the correct settings. It's an ask, but we cannot guess how the VFD is configured - you would be best reviewing the settings in the VFD and if no wiser, copy them out into this thread for others to review.

[Cozza]

If you've not done so already: You may (probably will) need to configure the VFD parameter set. There should be a manual provided (or link to) that describes the parameters, defaults etc, and you'll need to understand how to configure these with the correct settings. It's an ask, but we cannot guess how the VFD is configured - you would be best reviewing the settings in the VFD and if no wiser, copy them out into this thread for others to review.

Hi I have had a go but there's a lot to go through.


I'm really not sure what I should be changing but I did change the following parameters based on what I had read and seen on line.

P06 to 300
P21 to 2856
P26 to P33 to 300hz
P78 to P85 to 2900
P92 is set for 3 phase

I don't know if this helps?

Regards..

[Cozza]

Hi I have had a go but there's a lot to go through.


I'm really not sure what I should be changing but I did change the following parameters based on what I had read and seen on line.

P06 to 300
P21 to 2856
P26 to P33 to 300hz
P78 to P85 to 2900
P92 is set for 3 phase

I don't know if this helps?

Regards..

Does any of this look right to anyone?