LinuxCNC

[m_c]

When you run out of inputs/outputs.

I never went the Mesa route, as I was playing with some EtherCAT drives, but discovered a major show stopping bug, which nobody knew the cause off, or how to fix, so those drives/motors are still sat unused on the shelf.

[Chaz]

When you run out of inputs/outputs.

I never went the Mesa route, as I was playing with some EtherCAT drives, but discovered a major show stopping bug, which nobody knew the cause off, or how to fix, so those drives/motors are still sat unused on the shelf.

Thanks.

The kit you have, does it do step / direction too? If so, would you consider selling it for me to try and use (not in Ethercat mode)?

Thanks