Threaded View
-
10-01-2014 #11
Last Activity: 17 Hours Ago
I have used cy cable 1mm 4 core from the inverter to the spindle, 3 cores are for driving the spindle and the fourth core is to earth (my spindle has a 4 pin socket on it) on mine pin 4 was not connected to anywhere, I took the top off and soldered a wire from pin 4 to one of the socket mounting bolts on the spindle (I had to put a longer bolt in and then use a nut on the inside).
The shield on the cy cable is only earthed and the inverter end.
The mains cable to the inverter only need 1mm standard 3 core flex. ..Clive
-
The Following User Says Thank You to Clive S For This Useful Post:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Chinese 6040 CNC Router Advise Needed
By Bob Hepple in forum Chinese MachinesReplies: 24Last Post: 27-11-2013, 12:00 PM -
Has my air compressor died?
By Jonathan in forum General DiscussionReplies: 9Last Post: 15-10-2012, 12:08 AM -
I need advise again
By habibuzziwa in forum General DiscussionReplies: 14Last Post: 08-10-2012, 10:08 AM -
I need advise
By habibuzziwa in forum General DiscussionReplies: 7Last Post: 03-10-2012, 10:50 AM -
Advise on buying a new CNC router.
By brlaw in forum General DiscussionReplies: 2Last Post: 09-07-2011, 05:00 AM
Bookmarks