Parts need turning

[ams]

I cant change any dimensions unfortunately because these parts fit into the entire assembly, I'm sure there's room for error but it would be small and difficult for me to estimate. Anyone willing to take a crack at this?

[irving2008]

I cant change any dimensions unfortunately because these parts fit into the entire assembly, I'm sure there's room for error but it would be small and difficult for me to estimate. Anyone willing to take a crack at this?

You're going to need someone with a lathe & travelling steady (or sliding head) that can turn 20"+ between centres. Can't think of anyone here, with the exception of maybe JohnS, that has a big enough lathe. What's the tolerance on the 6.7mm?


Also, the 'cylinders' - do they have an internal bore? Or are they solid?

I know someone who has access to a cylindrical grinder, rather than a lathe, that might be able to do the long thin parts as a 'homer'.

[ams]

You're going to need someone with a lathe & travelling steady (or sliding head) that can turn 20"+ between centres. Can't think of anyone here, with the exception of maybe JohnS, that has a big enough lathe. What's the tolerance on the 6.7mm?


Also, the 'cylinders' - do they have an internal bore? Or are they solid?

I know someone who has access to a cylindrical grinder, rather than a lathe, that might be able to do the long thin parts as a 'homer'.

Hi

Yes the 2 cylinders have an internal bore, the other 3 smaller parts are solid. If there's someone you think would be able to take this on please message me and I can send across drawings and 3d models.

Thanks