Hi there from Gloucester, let's get building

**DrNik** · 15-03-2015

Hi Jazz, thank for your welcome

Ive got a standard PC up in the loft, I'll dig it out and get Mach 3 on it, or is there something better I can use?.

**JAZZCNC** · 16-03-2015

Originally Posted by DrNik

Hi Jazz, thank for your welcome

Ive got a standard PC up in the loft, I'll dig it out and get Mach 3 on it, or is there something better I can use?.

Ye but be damned If I'll tell ya if your who I think you are.!

**DrNik** · 16-03-2015

I've got some ideas on my table, have bought some stepper motors, 23 for y and z and 34 for x, I'm looking at timing belt on the x and only running one motor,pic below

2 pieces of timing belt tensioned on either side of the table, goes round a couple of bearings to keep the belt tight around pulley and then upto the top belt, maybe small timing pulley on motor to gear down the ratio, then passing the timing belt over to the other side, down the shaft and similar belt assemble onto other side, should be easy to time up and keeps it tidy