Coolant Pump

[andy_con]

Those are the ones, I can do you a vid over the weekend if you want.

Can't remember what size but they do one thats a perfect fit length wise.

As for power it's plenty of power for me, removes chips out the way nicely

[Chaz]

Those are the ones, I can do you a vid over the weekend if you want.

Can't remember what size but they do one thats a perfect fit length wise.

As for power it's plenty of power for me, removes chips out the way nicely

Thanks. A vid will be very much appreciated. Where abouts are you based?

[andy_con]

Essex .

[andy_con]

if you want a detailed conversation about a triac then I have plans to add an 10 station atc, it should fit right on without altering the atc setup

(I have some better drawings on my other laptop)

[Chaz]

if you want a detailed conversation about a triac then I have plans to add an 10 station atc, it should fit right on without altering the atc setup

(I have some better drawings on my other laptop)

Certainly, would be interested.

Is it just the wheel that needs to be changed?

[andy_con]

no, new drive system and add a stepper motor

[Chaz]

Essex .

Ah, OK, not too far then. Im based in Ickenham, West London.

[Chaz]

Those are the ones, I can do you a vid over the weekend if you want.

Can't remember what size but they do one thats a perfect fit length wise.

As for power it's plenty of power for me, removes chips out the way nicely

Hi mate, any joy with that vid?

Thanks

[andy_con]

best I could do sorry, didn't do any machining this weekend

[Chaz]

best I could do sorry, didn't do any machining this weekend

Thanks. Very helpful. You motor is on top whilst mine is in the cavity lower down (the full coolant system) so mine will have to pump a bit higher but not a lot more.

I could try and fix the motor setup I have, could machine a new based for it but probably not worth the effort. Id probably go for the 1/4 HP motor if I can get it to fit without cutting the sheetmetal.

Thanks once again.