DDSCV1.1 3 and 4 axis offline motion controller

[Boyan Silyavski]

I'm just trying to get a feel for whether it's a direction in which I should move, it does look like a great first foray into CNC solution, but given that I'm already au-fait and comfortable with Mach's Mumbo Jumbo I was looking for a step up rather than a step sideways and possibly down.

Although I've yet to have a PC fail I have upgraded my controller machine a few times to the point where it will hapily run my CAD/CAM. One very nice feature with Mach3 is that for approximately £60 I am able to have a fully configured, 100% functional backup PC with a new HDD on the shelf and any keyboard or monitor from my other systems can replace the ones on the CNC in the event of failure.

With any luck these all-in-one boxes will take off in the starter CNC market and grow with their customer base to offer enhanced capabilities,

- Nick

NIck, its true if all is working as its meant. Reality have shown otherwise.

For example:

Right now in machine i have LPT board from my old machine that was working perfectly there. But not here. Now probe will not work , spindle output will not work with correct PWM, from that results that my mach3 screen /MachStdMill / is not working 100%. All that why? because board is near the servo drives in the box, and not so near mind that.

But hey, before that i had the Pokeys that is Ethernet and 24v powered but 5v on inputs and outputs, so what? Same problems. Wait, i had the galil 8 axis board/ 600euro second hand/ even before that, but no support,DIY plugin and communication with pc good for the 80ies...and so on.

Do you know how much time i spend playing with boards and make them work? And when i did sometimes, it happens that after Ethernet board i had to change back to x86 windows, cause-hey mach3 will not work on a x64 machine with LPT. When all was fine then PC crashed ... I have 3 PCs for that purpose and thought like you think.


I would have bought one of the CSMIO rigth from the start , 24vdc, shielded, etc. But they made them so that they don't work with MachStdMill +the cheap one would not square at homing and is not so cheap at 300 euro. And the other one is quite steep at 800euro. And at that moment i cared about that, because i love that screen.



Now i care only to start machine and to work. What i am saying is that for a production, even if its home production, most important is when you start the machine -to work 100%. And yes, i could say the same- controller burns and i put another one inside it, program it for 1/2 and thats it. is not that the same?





In other words if i was happy with a combo for which i have payed 200 euro for software and 100-800euro for hardware, Why on earth would i be researching other possibilities and reading Chinglish manuals?


FIY i am looking now at the "next step" as you say it. So the answer is: yes there is, but not for 150 euro from china like the one we are discussing here. For the moment i have narrowed things to 980-990MDc overview and manual , there are even better ones - 1000 and 1500, but are priced near the model numbers and i think are out of scope for normal retrofit or DIY machine.