Quote Originally Posted by JAZZCNC View Post
Ok well first need to check if the machine is fitted with Ballscrews not just lead screws which you are calling Ballscrews.?

If ballscrews then 3 or 4Nm Nema 23 motors will probably work. I've fitted loads of Both 3 & 4nm motors and to be honest see very little difference between them in performance terms so wouldn't stress over which to use. The Key is buying ones with Low inductance. No higher than 4mh ideally closer to 3mh.
These are better motor and will fit your needs.
https://www.cnc4you.co.uk/Stepper-Mo...H401-03-Nema23

If you speak to them Don't Let them Bullshit you into believeing there drives are as good or better than Leadshine AM or EM they are not.!
Yes, definitely ball-screws. This is a very high-class bit of kit and would have cost many tens of thousands when new in 1980. The slides are conventional dovetails but have low friction inserts and are automatically pressure lubricated.

Thanks for the link and recommendation - will look into it.

Sorry to keep harping on about closed loop, but what do you think about using the Leadshine Nema23 kits?