Mach3 Setting up home and limit switches

[Neale]

What type of limit switches are you using? How have you connected them, and what BOB are you using? Need a bit more info before we all start guessing!

[CrazeUK]

What type of limit switches are you using? How have you connected them, and what BOB are you using? Need a bit more info before we all start guessing!

Hey. Thanks for your response.

The current ones set up are micro switches most are the 2cm ones.. I presume because of the size of the machine it doesn't require much more.

I am tempted to replace all of them with new ones.

All (including home and limit) are set up as always closed.

I am pretty sure the wiring for the limit ones (in series) is all checked through and is in series (was a bit messy when I got it) I've have tested it with a multimeter, and the resistance drops to infinity when I hit one.

The board is a CNC4X45A. Like the one attached:


I fiddled around with the pin numbers, the home switches are 10-12. The eStop is 15.
All are set to Low active.

Thanks.


Sent from my SM-N930F using Tapatalk