HELP Please 24V power supply went dead

[HiltonSteve]

I think 42V could be too high for the 25's from Roy, check the spec - http://www.diycnc.co.uk/html/driver25ps.html

What power supply have you got from Lee? the are adjustment pots on some which may let you turn the ouput voltage down but never tried it.

[m.marino]

I think 42V could be too high for the 25's from Roy, check the spec - http://www.diycnc.co.uk/html/driver25ps.html

What power supply have you got from Lee? the are adjustment pots on some which may let you turn the ouput voltage down but never tried it.

Model PS 407 Motion control unit
Thanks

[m.marino]

Model PS 407 Motion control unit
Thanks

I am trying to run three stepper off the one power supply.

Michael