Pci or Ethernet motion control?

[Clive S]

I guess by PCI you mean parallel port? Ethernet is far better but depends on the software you use. I am using Mach3 and UCCNC with the UC300ETH which is great.

No. The pci or pcie card by mesa is a motion controller with the step generation etc done in the hardware.

[A_Camera]

No. The pci or pcie card by mesa is a motion controller with the step generation etc done in the hardware.

Sorry I didn't know that. In this case one disadvantage of PCI is that it requires a dedicated desktop computer. The UC300ETH allows me to use laptops also and I don't have to have the PC and the CNC near each other since it is on my LAN through a router and LAN switch.

[Boyan Silyavski]

PCI i would avoid. For no other reason than if PSU of PC hacks up, the first think it does is burn all inside PC, hence your expensive PCI motion controller. I was repairing PCs at a certain point of time, so take my word on that. When it burns, it burns all. Nothing is spared.

I would greatly encourage you on the standalone controllers. As you know i run my machine on one with exceptional result. And can not stop bragging around how cheap and good value for the money, even with some small drawbacks. And if not the cheap one, there are even better ones for 500Euro.

Gone are the days i will use another controller if not for some very special retrofitting or very special machine.

[Clive S]

PCI i would avoid. For no other reason than if PSU of PC hacks up, the first think it does is burn all inside PC, hence your expensive PCI motion controller. I was repairing PCs at a certain point of time, so take my word on that. When it burns, it burns all. Nothing is spared.

Boyan I have to say you are talking blx. I also have been in PC's when you were in nappy's and I have never seen a pc PS "burn all inside" as you say.

And as you know the stand alone controllers are not yet mature enough to be singing the praises yet. This has been debated in another thread.

[Boyan Silyavski]

Boyan I have to say you are talking blx. I also have been in PC's when you were in nappy's and I have never seen a pc PS "burn all inside" as you say.

And as you know the stand alone controllers are not yet mature enough to be singing the praises yet. This has been debated in another thread.

I know your opinion already on the controllers. Do as you like. I am just giving mine opinion. Mature or not, i am cutting happily and reliably.

And no, you dont have to say- you like to say, which is a totaly different thing. Not respecting others opinion and experience when different than yours is a personal choice.

[Clive S]

Sorry I didn't know that. In this case one disadvantage of PCI is that it requires a dedicated desktop computer. The UC300ETH allows me to use laptops also and I don't have to have the PC and the CNC near each other since it is on my LAN through a router and LAN switch.

Yes I agree but does the UC300ETH support rigid tapping and multi encoders?

[Ger21]

Yes I agree but does the UC300ETH support rigid tapping and multi encoders?

It's supported rigid tapping for a very long time.
Encoder inputs were added to the latest version. But what you do with the encoders is entirely up to you. You need to write macros or a plugin to do anything with the encoder data.

[A_Camera]

Yes I agree but does the UC300ETH support rigid tapping and multi encoders?

I don't know. I think it supports tapping but don't know about the multi encoders.