g31 code probe

[warwick]

thanks for your help yet again chaps.thankyou

[A_Camera]

thanks for your help yet again chaps.thankyou

Good luck. I hope this was what you had in mind. Just be careful, the values above are only suitable for my machine and you should be careful before you are comfortable with it. Make sure you are using millimeters, or change the units in the code for inches. If you'd lower the Z with 400in/min, as opposed to 400mm/min which is what I am doing, you'd crash your machine and the probe or the probe plate or the CNC would get some serious damage.