Way out of my depth

[Paul3112]

the common way to wire limits and estop is a normally closed loop. so any fault in the loom will not let machine start.
I would be looking for the manual for the drives to see what the config is set at.

[jenxmetalworks]

the common way to wire limits and estop is a normally closed loop. so any fault in the loom will not let machine start.
I would be looking for the manual for the drives to see what the config is set at.

That's good advice I have found manufacturers id plate it was made in USA by vytek Massachusetts 2005 I'm going to email them see if they have any information on it I'll report back
Thanks


Sent from my iPhone using Tapatalk