Hi. Heres my work

[Ukmiller]

I did the job start to finish using some edgecam and some online programming.
Using 3 axis hardinge 1000 at work.
It was a big lump! Over 100mm thick so took a while to get it cut out.
I used about 30 different types of tools for this job.
I use feeds and speeds i have learnt from experience and up to 6000rpm.
Supporting it wasnt easy and i bolted it to some paralells from undernearth.
Took me 55 hours.

[magicniner]

I used about 30 different types of tools for this job.

That's impressive, I don't think I have 30 different types of tool, not even sure I can think of 30 different types of tool for use in a milling machine ;-)

- Nick

[Ukmiller]

That's impressive, I don't think I have 30 different types of tool, not even sure I can think of 30 different types of tool for use in a milling machine ;-)

- Nick

From memory i used 80mm face tool and long series drills to create a way to mount to paralells.
Then a long 10mm 3 flute to cut off excess material.
Then roughed out with 80 and 50 facemills.
Then various sized end mills and ballnose to achieve shapes. Then many different drills and taps and finally long series tools to do the top angled fine pitch sensor hole.
The item was for atomic testing agency