looking for a good 3d printer

[Ross77]

Cool. Have you printed anything? Are you happy with it? What's your impressions so far?

Yes lots of failures but I guess its a learning curve. I had bed leveling issues and poor prints with layer shift, since found out that the 2 or the 3 screws holding the main x-y carriage where missing and the 3rd was loose.

tightening them has solved the layer shift but Im still getting 1mm variation on the bed calibration. guys on the forum think it is the micro switch but it seems to work fine when I tested it with a meter.

I think it will be a good machine but needs a few tweeks and lots of wear, the previous owners must have used it a lot.

biggest issues that i missed when researching are the bowden extruder and being stuck with the wanhao maker slicer program. (firm ware upgrades to 3d partry but not brave enough to try)