Huanyang VFD current draw measurements.

[Edward]

"Hmmm, unfortunately there are too many variants that affect the actual current draw of a particular device, for instance the forces applied at the cutting end."

Incorrect
0/10

Puerile as puerile goes. But whatever:)

[magicniner]

"Hmmm, unfortunately there are too many variants that affect the actual current draw of a particular device, for instance the forces applied at the cutting end."

That's quite obviously utter bunkum, otherwise nothing electrical other than simple resistive load systems in industry could ever be built to a specification without years of iterative testing, fettling and re-testing.

0/10 seems extremely apt as it happens ;-)

You're saying that something calculated every day by professional engineers cannot be calculated - you're full of it and don't like that you are demonstrably incorrect, I suggest you get used to it as you seem hell bent on continuing the pattern :D

[Edward]

Hmmm, you are waffling and sidetracking and you know it, you know very well what I was referring to. This silly point scoring and displays of bravado don't do you any favours. It makes you look bad.

I suggest you apply your energy and knowledge (which I'm sure you have in abundance) to better use, as practically all the other knowledgeable posters do, to whom I am grateful.

End of story, I let you have your last word, because of course, you must.

Edward