new build - Rails & ballscrews & motors

[CNCBlug]

What kind of speeds do you need?
the driver you have selected is limited to 50V Max, so realistically the best voltage to use is about 40V, so will be a bit low for larger motors, and this will limit the max speed.

Hi Gary

Yes, this is now where my knowledge is severely lacking.

TBH i dont know what speed i want/need.

I suppose the question is not which motor I need to use with the driver, it more "What driver/motor combination will do the job".

I would rather go big and cruise than small and strain. What would you suggest Gary?

[Gary]

Without spicifics it is not possible to advise what to use.
What you need to look at is the speeds you need while cutting and during rapids, and the amount of force you will need.
Without this information it is just stabbing in the dark.
If you want you can give me a call tomorrow to discuss you application in more detail.

Hi Gary

Yes, this is now where my knowledge is severely lacking.

TBH i dont know what speed i want/need.

I suppose the question is not which motor I need to use with the driver, it more "What driver/motor combination will do the job".

I would rather go big and cruise than small and strain. What would you suggest Gary?