Search:

Well, I've finally gone and bought one. I went for the new Bambu Lab P1S with AMS in the end. Seems to have good reviews, and the X1C was considerably more expensive for what seemed like a similar...

Hi EZELab
Welcome to the forum.
I would like to point you to John McNamara's epoxy build( https://www.model-engineer.co.uk/forums/postings.asp?th=139042)
A very thorough and informative thread....

Try this one.

It's not easy to find things like this when the last post to it is more than a week or two back - they just get lost in the noise!

In fact, it's about as easy as finding the...

Hi

I was asked if would share the Drag Knife plans

here you go..

Hi Phill,

Ive not done a lot with it as yet as Ive had to solve some other issues.

The platform is good and stable. Inherently more so than Mach which solves many issues. Support however is...

£70 ish. Ordered on Sunday night, received Wednesday same week.

If declared properly, IIRC it's 2.2% duty, plus courier handling fee, plus 20% VAT.
So if you budget 23% for the governments cut, then £10-25 for the couriers fee, it'll give you a rough idea.

i will keep posted for anyone else interested because if i can figure it out then anyone can as i have no experience at all but i do love a challenge.

That's how I have it setup the black cables are the stall protection
23253

Powered on today ;) can't test it because I took the Z axis plate off and it's still with engineering firm although...

You have 4 axis so use the C axis for the slaved drive. Honestly wouldn't use 1 output for 2 drives if you have a spare output which you do.!!

Yes this is common setup and you can control all...

Thanks Irving, I'll do that.

Chris

1 step.... suggest you check step and direction are not swapped over...

Get a multimeter and find which two wires make up a coil.
You have 4 coils so you will have 4 pairs of wires.

I'm guessing Black and white with black stripe is one ?
Red and white with red...