New start

[driftspin]

Alright :D

First test cut made!



Was a bit of difficulties at first.
Got spindlecontrol working at first but with mayor problems.
Estop was tripping and uc300 was loosing connection from computer.

Disconnected speedcontrol from bob and ran only the start relay. Worked better!
Then when I started jogging the machine with spindle on I got false e stop again :(
Disconnected e stop from bob and only had it to control master relay.
Got the problem that when jogging two axis simultaneous uc300 disconnected.
I think the problem is my 5v psu so I hijacked 5v from my pc psu and ran to uc300 so that got powered from pc and the bob/driversignals from separate 5v psu.

This made it work :D :D

I have not reconnected spindle speedcontrol but Im guessing that works now too..!
Homes are working but my slaved axis (x/a) needs a bit calibrating. When cutting a grid of 300x300mm I get about 1mm differens in the diagonals. But there is plenty of adjustment available in the home sensor brackets so it's no biggie :D

Skickat från min SM-G955F via Tapatalk

Hey Nr1madman,


Congrats on the first cut.

Grtz Bert.

Verstuurd vanaf mijn SM-A320FL met Tapatalk

[Nr1madman]

Hey Nr1madman,


Congrats on the first cut.

Grtz Bert.

Verstuurd vanaf mijn SM-A320FL met Tapatalk

Thanks :D

I hope to say the same to you soon!

Skickat från min SM-G955F via Tapatalk

[Nickhofen]

2amperes is good but how thin are the wires?

[Nr1madman]

2amperes is good but how thin are the wires?

It's 0.5mm2 wires. So they should be more than fine. They just feel thin/flimsy.
I'm used to 1.5mm2 wires ;)

Skickat från min SM-G955F via Tapatalk

[Nickhofen]

You are just fine,according to this :

[Nr1madman]

You are just fine,according to this :

So I thought :)

Skickat från min SM-G955F via Tapatalk