Leadshine EM806 - Am I using them properly?

[Ger21]

If your spinning the motor faster to try and get more torque, you may actually end up with even less torque.

Those huge motors usually have very little torque over 500-600rpm.

[Chaz]

If your spinning the motor faster to try and get more torque, you may actually end up with even less torque.

Those huge motors usually have very little torque over 500-600rpm.

Thanks Ger. This is what has been recommended to me too. With the Acorn tuning where there are 2 parameters, it will thread OK.

My 2nd lathe has an issue with the encoder which I hope to fix today, will then test back to back and see.