Losing steps

[Edendale]

Hi Dean, you were right, I ran a file and lowered speeds & feed and it didn’t lose any steps, guess I’m just going to have to be more patient, I contacted the seller in China about the wiring fault and they sent me a replacement breakout board & stepper driver in case I have problems,
Regards Mike.

[JAZZCNC]

Hi Dean, you were right, I ran a file and lowered speeds & feed and it didn’t lose any steps, guess I’m just going to have to be more patient,

Hi Mike, yes, unfortunately, that's the problem with these cheaper machines, they are great for learning on but they are slow and limit the quality of what can be done. However, if your patient can still give very rewarding results.

[Edendale]

I’m saving up to come see you again ��

[JAZZCNC]

I’m saving up to come see you again ��

Ah ah sorry Mike just realised who you are. . . Lol . . . Yes any time mate your always welcome.