Quote Originally Posted by JAZZCNC View Post
That's WRONG information your giving out, the drives don't regulate the voltage they regulate the current. 70Vac which is 98Vdc would destroy those little motors in no time at all. It would also make them run like a bag of shite.

You cannot stick any voltage you like into a stepper, there is a limit where it starts to have very negative affects. Namely iron losses and motor heating which kills them.

Those Large voltage Ac drives are only really any good for larger steppers Like Nema 34 or very high inductance NEMA 23's. Your typical 3-4Nm 4.2a Nema 23 with 3-4mh inductance doesn't like to be run much more than 80vdc and at that, you are pushing them past there design threshold so are shortening there life.

For the NEMA 23 motors, which this machine will have fitted he'll only need drives with a max rating of 70Vdc and would run them around 55-60Vdc. Or 50Vac drives running at 40-45Vac.
Steppers are generally all rated 2-3Vdc yes?. So if said nema 17 / 23 or 34 (2-3Vdc) were put on the same driver why would I only blow the 17? (unless I didn't change the current output).

Also inductance. There are Nema 34's out there that are abysmal running on 60V supplies and ideally need at least 120Vdc to work reliably.

Also there are now drivers on the market with direct 240Vac input connections so no need for psu's anyway. These are aimed at nema17-23 size. Why would these not burn them up either?

I and many others use 60Vdc at least using larger 34 size drivers to run nema17 & 23 size motors. Even that goes against the grain and it's worked for years.