Thread: moving from Mach3 to AXBB
Threaded View
-
11-04-2020 #3
And DO backup your profile (default.pro) otherwise sooner or later you'll find yourself unable to start it up without entering all your settings again......
I wouldn't sweat it. Get a couple of mugs of tea on the boil and a pack of hobnobs. It'll come good.- though I didn't try cutting anything then obviously!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
AXBB-E any opinions?
By ngwagwa in forum Motor Drivers & ControllersReplies: 12Last Post: 21-07-2021, 04:32 PM -
Help needed to connect my VFD to the AXBB controller
By CharlieRam in forum Spindles & Drive MotorsReplies: 24Last Post: 23-09-2020, 12:10 PM -
AXBB-E licence key problem
By Voicecoil in forum CNCdrive (UCCNC)Replies: 15Last Post: 26-01-2020, 02:22 PM -
CNCDrive AXBB super deal?
By driftspin in forum CNCdrive (UC100, UC300ETH)Replies: 18Last Post: 16-03-2019, 10:10 PM -
moving mach3 help please
By h4ppy-chris in forum Artsoft Mach (3 & 4)Replies: 12Last Post: 07-03-2011, 07:33 PM
Bookmarks