. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 17-04-2020 #3
    Kitwn's Avatar
    Lives in Don, Tasmania, Australia.
    Kitwn
    Last Activity: 15-07-2024 Has been a member for 7-8 years. Has a total post count of 983. Received thanks 118 times, giving thanks to others 52 times.
    Quote Originally Posted by Desertboy View Post
    If I am going to set it up with linuxcnc want dual homing on the bottom axis.
    This thread will help you with this bit:

    http://www.mycncuk.com/threads/12687...LinuxCNC-v-2-8
    An optimist says the glass is half full, a pessimist says the glass is half empty, an engineer says you're using the wrong sized glass.
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to Kitwn For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. On closing Mach4 spindle switches on!!
    By V8kid in forum Warp9 (SmoothStepper)
    Replies: 2
    Last Post: 05-04-2020, 12:47 PM
  2. Maplin closing-down sale
    By Doddy in forum Classified Ads, Buy, Sell & Swap
    Replies: 0
    Last Post: 13-03-2018, 09:13 PM
  3. DIY Rotary Encoders?
    By birchy in forum Electronic Project Building
    Replies: 3
    Last Post: 15-09-2013, 03:09 PM
  4. Closed Loop Stepper Compared with Open Loop Stepper
    By Leadshine-Erci in forum Stepper & Servo Motors
    Replies: 0
    Last Post: 25-05-2012, 08:11 AM
  5. optical encoders for stepper motors
    By lateAtNight in forum Stepper & Servo Motors
    Replies: 2
    Last Post: 21-06-2009, 12:54 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules