Threaded View
-
05-05-2020 #11
Last Activity: 14-01-2024
Hello Dean,
In a lot of post you talk about CSMIO controller. Are you going to switch to Puruvesi controller, what the pros/cons of ET6/7 over the CSMIO IP/S ?
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
10% off our myCNC controllers for MYCNCUK users
By ivan-mycnc in forum Manufacturer NewsReplies: 6Last Post: 08-01-2020, 03:56 PM -
Height Mapping using myCNC controllers
By ivan-mycnc in forum Manufacturer NewsReplies: 0Last Post: 19-11-2019, 05:26 PM -
NEW MEMBER: New to MYCNC and looking for help
By Crafty Angel in forum New Member IntroductionsReplies: 0Last Post: 20-08-2016, 07:16 PM -
NEW MEMBER: New to mycnc
By first timeER in forum New Member IntroductionsReplies: 2Last Post: 19-02-2015, 11:31 PM -
I'm guessing that peeps do have lives outside of MyCNC...
By WandrinAndy in forum General DiscussionReplies: 9Last Post: 06-09-2012, 10:03 AM
Bookmarks