Converion based upon my old Deckel Mill

[Kitwn]

This forum entry refers to the problem and sugests a solution.

https://cambamcnc.com/forum/index.ph...sg6459#msg6459

To change the post-processor click on the 'system' tab, and select the correct post-processor from the list in there. If this doesn't work then try a search on the CamBam forum. Copy and paste the error message into the search box. There are plenty of results to choose from!

[John11668]

This forum entry refers to the problem and sugests a solution.

https://cambamcnc.com/forum/index.ph...sg6459#msg6459

To change the post-processor click on the 'system' tab, and select the correct post-processor from the list in there. If this doesn't work then try a search on the CamBam forum. Copy and paste the error message into the search box. There are plenty of results to choose from!

Been to the forum and this does seem to be a common problem, but there are hundreds of similar blocks in the code so editing isnt going to be the answer.
Have tried changing the PP to Mach 3 but the indicator ( green arrow )stays at default . Does this only work on licensed version perhaps ?