I need help

[Marcus0121]

Ok well thank you Jazz. You have been a massive help. I don’t know if you know but I have to ask. Should I program the VFD. I have all the info needed to do it but I’m not sure if it will be preprogrammed. My direction would be to program the VFD and then follow your instructions to finish off the rest. I just don’t want to blow anything up or fry anything. What do you think ??

[JAZZCNC]

Ok well thank you Jazz. You have been a massive help. I don’t know if you know but I have to ask. Should I program the VFD. I have all the info needed to do it but I’m not sure if it will be preprogrammed. My direction would be to program the VFD and then follow your instructions to finish off the rest. I just don’t want to blow anything up or fry anything. What do you think ??

It takes just a few minutes to check the parameters so it's worth giving them a quick look at because not all are setup.

[Marcus0121]

Ok so I have the control box and the VFD all hooked up and have power going to both of them. I can start the spindle up and control it with the VFD. I have a parallel port to CNC connection which I have inserted and I have downloaded mach3 and CNC usb. I would prefer to use the mach3 if I can as it’s easier to use. I followed the set up videos for mach3 and it’s not working. There is no power to the motors. Next problem to overcome ?? Anyone got any ideas ??