OpenBuilds Style Build

[mekanik]

Main reason for using water cooled Spindle is the noise or lack thereof, you need an inverter as they they are three phase, you need to provide a small tank and a pump. you will be fine with an ordinary router but again it's the noise, this would get very old if you are doing a long run on the machine, you need also to be looking at a dust shoe to fit whatever device you wish to use.
Good luck
Regards
Mike

[WoodKnot]

Main reason for using water cooled Spindle is the noise or lack thereof, you need an inverter as they they are three phase, you need to provide a small tank and a pump. you will be fine with an ordinary router but again it's the noise, this would get very old if you are doing a long run on the machine, you need also to be looking at a dust shoe to fit whatever device you wish to use.
Good luck
Regards
Mike

The motors then are quite large? Even compared to a good half inch router then?

Can you recommend a pump and tank Mike - it sounds like an aquarium!

Just trying to figure out what I will need -

WoodKnot