. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 12-12-2021 #7
    A_Camera's Avatar
    Lives in Where my home is, Sweden.
    A_Camera
    Last Activity: 4 Weeks Ago Has been a member for 8-9 years. Has a total post count of 709. Received thanks 103 times, giving thanks to others 40 times.
    Skip one driver and switch the control signals step, dir, enable and gnd. This is what I am doing on my DIY lathe / 4th axis combo. I would not switch the stepper wires. Beware that if you have some interference then you might get some extra steps, so you must be careful with the wiring.
    Last edited by A_Camera; 12-12-2021 at 11:12 PM.
    My videos
    My blog
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How to wire the enable pin on a stepper drive?
    By cncJim in forum General Electronics
    Replies: 8
    Last Post: 01-01-2016, 05:10 PM
  2. WANTED: parker CD20 stepper drive
    By drumsticksplinter in forum Items Wanted
    Replies: 0
    Last Post: 29-03-2014, 03:35 PM
  3. Wanted: Parker CD20 Stepper Drive
    By drumsticksplinter in forum Classified Ads, Buy, Sell & Swap
    Replies: 0
    Last Post: 29-03-2014, 03:33 PM
  4. What voltage for stepper drive?
    By Davek0974 in forum Plasma Table Machines
    Replies: 1
    Last Post: 22-01-2014, 10:49 PM
  5. BOB & Stepper Drive
    By GTJim in forum General Electronics
    Replies: 9
    Last Post: 22-08-2013, 07:17 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules