step and dir pulse problem Mach3

[mrmacca]

Hi All,
been having a go at building onto the AXXB-E attached are some pics and would like advice as to were I have gone wrong on the stepper drives, also the 3 wires lying by the AXXB-E are from the VFD av1 grnd and +10v were do i attach these to the AXBB-E, also emergency stop and pump.
All the advice i have had up to now is much appreciated.

[JAZZCNC]

Hi All,
been having a go at building onto the AXXB-E attached are some pics and would like advice as to were I have gone wrong on the stepper drives, also the 3 wires lying by the AXXB-E are from the VFD av1 grnd and +10v were do i attach these to the AXBB-E, also emergency stop and pump.
All the advice i have had up to now is much appreciated.

Be Careful if you don't know what you are doing because you can easily damage the controller if you connect up wrong. Don't turn it on until you are 100% sure it's correct, you can't afford to use a trial and error method here because you won't get a second chance once you let out the magic smoke.

I will knock you up some simple diagrams but it will be tomorrow now, I suggest you wait rather than have a go without being sure.

[JAZZCNC]

Ok, here you go. I have broken each down into separate drawings.

On the VFD you don't need the 10V with AXBB so just remove the wire.



Edit: My drawings show Step which is Puls on your drives.

[mrmacca]

Cheers Jazz,
no would not have turned it on and still wont till im sure , thats why i asked for help lol.
Actually had another read of the manual and spotted where I have gone wrong.
Cheers M8