Help Mach3

[dazp1976]

Hi, I have attched two pics I have used a four lead from driver to breakout board is this OK

Mike

Not very informative. Do you have it wired as per post #12?.
These boards do require a 12-24v supply added on the right hand side to run the spindle control AND the inputs. The 5v usb supplies the outputs only.
I see you don't have the larger supply yet so....

Is E-stop turned off in Mach3?.
Do you have power to the driver?.
Some drivers require the enable signal to be used.

Are the wires actually the same config on both board and driver?. Or did you not look and just plug it in?.

I need a close up of the driver connectionns showing the symbols/names, or written down. Pul+/- dir+/- en+/- etc.