Steel Framed Router

[Ricardoco]

Rick, I've attached a zipped copy and hopefully it has worked.

Ok ive just done enough tinkering to give you an idea, of where bracing could do with looking at.

It may also be an idea to widen up underneath the table on the gantry just enough to stop the diagonal flex when the spindle is working at the far reaches of the gantry axis.

I built a table router very similar to this one some time ago and that is the only real problem area i had to re-think..

I would have put a double row but unless your stepper was on top it wont fit.. Good luck with the project i will be interested to follow your progress, its always nice to see projects from concept through to completion..

All the best Rick