Thread: ATX cycling fault?
Threaded View
-
07-12-2011 #4
There is one pin on the PSU which acts as an enable. Perhaps try measuring the voltages from the PSU to verify that none of them are outside tolerances, just in case?
I had an old computer recently that did what you described. Turns out it was the processor than had died.
Why would anyone do that.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Plasma cutting fault diagnoses....
By Davek0974 in forum Plasma Table MachinesReplies: 15Last Post: 01-04-2014, 07:04 PM -
heidenhain vrz731b fault
By p.cage in forum General ElectronicsReplies: 0Last Post: 31-01-2014, 03:56 PM -
Servo fault handling
By m_c in forum Motor Drivers & ControllersReplies: 0Last Post: 23-09-2013, 04:39 PM -
Heidenhain DRO fault
By Lancer in forum General ElectronicsReplies: 5Last Post: 29-06-2012, 09:57 AM -
Denford Triac Spindle Fault
By Sam_Smith in forum Denford MillsReplies: 5Last Post: 04-05-2011, 11:07 PM
Bookmarks