3 Axis CNC router

[John S]

Ta, got it.
Also found the DXF for it.
Translated onto brass at 120mm round 20 degree V carve it says 2 hours 57 cutting
90 degree cutter is 1 hour 43

[Jonathan]

Probably got it twice.

I think 20 degree will cut a bit too deep? I doubt the time estimates will be anywhere near unless your machine acceleration is exceptionally high. Still it'll be interesting to find out.

[JAZZCNC]

90 degree cutter is 1 hour 43

If I remember right thats roughly about what it took me when I did it.?? But it's been that long since I did it I can't remember.

Like Jon says 20 deg will cut deep but I'm sure you will have sussed that and limited it's depth.? I've seen a nice one done with aspire that cuts the bottoms of deep area's flat and rest Vcarved.