Square Ballnut??

[JAZZCNC]

As usual sourcing the bits i need and came across this but as you can see from the link they have not stock, any ideas where else i can get them in the uk..




http://www.wmh-trans.co.uk/Products/...PE/R16-5B1-SSV

Have you spoke to them.? (WHM) If not then it may be worth doing so has they may be able to have one sent direct from Germany via FedEX.?

[Ricardoco]

Have you spoke to them.? (WHM) If not then it may be worth doing so has they may be able to have one sent direct from Germany via FedEX.?

Well before i noticed they had no stock i spoke to them about machining the ends of the ballscrews £100 per screw or £5 to aneal the ends, so 30mins later i picked myself up of the floor and he had gone when i picked the phone up again....LMAO it was then too late to ring them back