Help with settings!

[Jonathan]

Did you also use a rotating ballnut on the sideways axis?

No, there wasn't any reason for me to do so on such a short axis. It just adds complexity.

The long axis is 1610 with and 1.5m. I don't know if it is fully reliable at 10m/min but jogging it doesn't stall.

That's similar to mine, so about what we expected. What have you set the acceleration to as in the video it looks a little low?

[Tenson]

No, there wasn't any reason for me to do so on such a short axis. It just adds complexity.

So it was just a cheeky quip? How nice of you, even though I paid you for the parts.

The acceleration is low at the moment since the machine isn't working fully yet.

[Jonathan]

So it was just a cheeky quip? How nice of you, even though I paid you for the parts.

I guess so, but I apologise if you considered the response cheeky as that was not my intention. If I recall correctly I advised not to use one on the shorter axis, but you had other reasons to use it which seemed fair enough and it shouldn't make the machine perform worse, so I made it.

The acceleration is low at the moment since the machine isn't working fully yet.

I see.. looking forward to seeing it cutting soon.