6mm Carbide CNC Router Bits for 3mm's

[Jonathan]

I've got 10 1/8", 12mm CEL, single flute cutters if that's any use? What's the exchange rate?

For wood 3-4 flute isn't going to work very well compared to 1-2fl. Particularly for such small cutters, where there's not much room for the swarf, I prefer to use single flute.

[Fivetide]

They are a 2mm shank. 8mm flute length and a 28mm long shaft.

I only have a 3mm / 5-6mm and 6-7mm collets Goblin so thanks for the offer :)

I've got 10 1/8", 12mm CEL, single flute cutters if that's any use? What's the exchange rate?

For wood 3-4 flute isn't going to work very well compared to 1-2fl. Particularly for such small cutters, where there's not much room for the swarf, I prefer to use single flute.

They are perfect Jonathan, I want to keep 3 so that leaves 7 2 for Jazz I think so I have five left, If you have some 3mm shank 2mm single flutes ( does CEL mean Carbide?) we could mix and match. £50 / 10 so £5 each, it was free postage. So what youpaid for yours to the same amount cost wise from me ? Does that make sense lol ? I'm shit with money tbh :( I can get them in the post in the morning Jonathan if you send me a PM with addy. You see I like swaps much better than cash sales, no money transactions the old bartering system..