View Poll Results: Mach3 vs LinuxCNC/EMC What do you use and why?
- Voters
- 28. You may not vote on this poll
Threaded View
-
30-12-2012 #11
Obviously not geek enough then the understand what they are leaving?????
It's horses for courses, the same goes for the linux sites. Like i said it is all about the circles you walk in. As John pointed out is about familiarity not necessarily one being better than the other. Linux does allow you to get under the bonnet and what you do with it is swings and roundabouts.
Not Yet.!! . . . . . And if you get on the Yahoo or Mach forum you'll see loads of returns and even more who started with linux due to low finances and say how much more comfortable they are with Mach.!If the nagging gets really bad......Get a bigger shed:naughty:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Ubuntu 10.04 / Linuxcnc / heekscad & heekscnc -installation (steps of what I did)
By diy-john in forum CAD & CAM SoftwareReplies: 5Last Post: 19-06-2013, 07:35 AM -
LinuxCNC and Zapp Automation 3 axis kit - how to configure?
By gr8fun in forum LinuxCNC (EMC)Replies: 12Last Post: 10-04-2013, 09:11 AM -
How many LinuxCNC/EMC users do we have?
By birchy in forum LinuxCNC (EMC)Replies: 16Last Post: 30-12-2012, 08:08 PM -
Setting up LinuxCNC (Linux newbe)
By Mad Professor in forum LinuxCNC (EMC)Replies: 1Last Post: 04-03-2012, 09:22 PM
Bookmarks