reassuring to see

[Saracen]

> two of the Z bearing blocks are only half attached by two bolts

There are four holes in the back plate for the lower z axis blocks, so it looks like someone moved the blocks up to get the cutter head nearer the bed.

Adrian.

[Shinobiwan]

> two of the Z bearing blocks are only half attached by two bolts

There are four holes in the back plate for the lower z axis blocks, so it looks like someone moved the blocks up to get the cutter head nearer the bed.

Adrian.

The Kress isn't the original spindle. There was a small chinese vfd jobbie on there when I saw it. That's probably why the block is moved up since the kress is shorter.