Ready Steady Eddy

[cncJim]

Visio but any 2D CAD will do, it's just that I had already created the symbols with it. By the way a good source for electrical symbols is the Telemecanique catalogue, you have to draw them youself and save as a block but it's still a great resource.

Ah ok - I have access to visio so I guess its time to learn how to use it!

The spindle is an ELTE 2.2kw TMPE3 12/2 and has a built in switch for temperature.

That's interesting. I was thinking about this and is it a good idea to have the spindle over temperature hooked into the estop circuit? My thinking being that if the spindle starts to over heat, I would for sure like to be made aware of it but I wouldn't the whole machine to emergency stop and risk damage (would anything potentially be damaged as a result of an estop or have I got the wrong end of the stick? I have read different things/advice so far. Obviously if it was a real emergency then damage to the equipment is the last thing to worry about). Maybe a two stage system with a warning buzzer/light when the temp hits the first level and then estop if it rises to the next level? Sorry just thinking out loud!
*

In my panel all the low level signal wires go in the right hand vertical trunking while the stepper motor and power wiring are in the left hand vertical trunking. The stepper motor wiring and spindle motor wiring are in screened CY cable, all screens earthed at the terminal rail and nowhere else.
If anyone is concerned, it might be worth their while to look up IP2X for electrical panels, one way is to put a full perspex sheet over the whole guts secured by screws at the corners.

I think that is how I will approach the wiring. Thanks for the reminder on IP. Many years ago I used to work in electrical testing and I can just about remember some of the testing we used to do for IP.