DSP controller questions, Will this work well with Deskproto as my CAM software?

[JAZZCNC]

Does not matter which Cam you use so long as you save the Tap file as G-code save to USB stick, then place into DSP select file, set machine parameters then run.

Phill

That may not be exactly correct.? . . The post processor will need to be correct and the DSP could need a specific Post.!

I would hazzard a guess that it just use's standard G-code so most basic Post's like for Mach or Linux cnc would work but it could also need specific Headers etc to set the DSP up.? . . . The manual should tell you.!