Mach3 ports and pin setup to match my control box

[Sparky]

Hi Jazz
Thank you for that, but unfortunately that did not work.

[JAZZCNC]

Hi Jazz
Thank you for that, but unfortunately that did not work.

Think you best explain again the problem because changing the keys would change the direction unless you didn't apply the changes by clicking ok.?

The other thing to try and really what you should have done instead of changing the X motor active state is to use the Reversed option in the Homing/limits. So set the X motor state back to previous state and try this and between this and changing the keys you'll get moving in the right directions.