1800x800 bed or 1200x800 and cut big panels in 2 goes?

**charlieuk** · 03-11-2014

If you build it so the axis on the gantry was your long axis at 1200 then you could at a later point just build a new table for larger sheets and use the same gantry. you could also slide a full or half sheet in and do a series of cuts to start with on the small machine.

**Boyan Silyavski** · 03-11-2014

Originally Posted by charlieuk

If you build it so the axis on the gantry was your long axis at 1200 then you could at a later point just build a new table for larger sheets and use the same gantry. you could also slide a full or half sheet in and do a series of cuts to start with on the small machine.

Thats what i am bragging about

**JAZZCNC** · 03-11-2014

If you have free wall then make it vertical then you can probably cut full size sheets.!!. . . .. Massive space saving to be had with vertical machine.???
Just think horizontal machine tipped on it's side.!!!. . . . It works trust me.