New member

[njhussey]

Thanks Neil,

Still a little unsure which way to go. Was looking at the IP/S but i think i would go with an open loop system if i bought this due to budget restrictions! I could always sell the IP/M to offset some of the cost. I had a look through your build log , thats an impressive looking Control box! I think when i eventually get all electrical parts on the bench i will be using some information from your log if you dont mind.

Thanks Philip

Use whatever you like from the build log, that's what it's up there for! I'm just about to go and do some more wiring on it after a 6 week or so break...struggling to remember what I was going to do next!!!

[Lee Roberts]

Hi Philip,

Welcome to the forum and good luck with your machine.

.Me

[philgiggins]

Hi Philip,

Welcome to the forum and good luck with your machine.

.Me

Thanks Lee, if and when i get it finished ill post some pics!

Use whatever you like from the build log, that's what it's up there for! I'm just about to go and do some more wiring on it after a 6 week or so break...struggling to remember what I was going to do next!!!