Installing Mach 3 is driving me mad!

[tonygagey]

Clive S
Angular properties was checked , i unchecked them.
home slaved with master was unchecked and I checked that and it all seems to work! will try again in morning to confirm but so far so good.....

[Clive S]

Clive S
Angular properties was checked , i unchecked them.
home slaved with master was unchecked and I checked that and it all seems to work! will try again in morning to confirm but so far so good.....

OK and take note of what Gerry has to say. The motor tuning, Acc and steps etc has to be exactly the same on both the slaved motors. ..Clive

[Ger21]

Does the A axis have it's own home switch, or do you only have one on the Y axis? (Sounds like just the Y axis?)