. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 10-09-2015 #31
    Davek0974's Avatar
    Lives in Bishops stortford, United Kingdom.
    Davek0974
    Last Activity: 20-12-2024 Has been a member for 9-10 years. Has a total post count of 1,165. Received thanks 78 times, giving thanks to others 226 times.
    Quote Originally Posted by JAZZCNC View Post
    If all wired same and the drive doesn't have an active edge Dip switch then probably because setup different in the drive software. Some drives will provide a Dip and most Digital drives you can access thru software.

    If none of the above then could just have been set different at the factory,?
    But these were tested with a different BOB when i was building the table and all settings were the same????

    One difference is that the test PC was underpowered and only ran at 25khz, the work PC runs at 45khz, step and dir pulse length is 2us on both PC's
    Last edited by Davek0974; 10-09-2015 at 07:12 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. New Build-12x6ft Plasma Table
    By F1transportationserv in forum Plasma Table Machines
    Replies: 23
    Last Post: 04-07-2015, 12:14 AM
  2. Plasma table build, first question....
    By Davek0974 in forum Plasma Table Machines
    Replies: 51
    Last Post: 01-08-2014, 03:11 PM
  3. 4' x 4' plasma table build in Canada
    By 190-v8 in forum Plasma Table Machines
    Replies: 0
    Last Post: 29-01-2014, 12:27 AM
  4. BUILD LOG: Let The Fun Begain, New build on the Table.
    By Bush Flyer in forum DIY Router Build Logs
    Replies: 63
    Last Post: 20-11-2013, 09:19 PM
  5. 3M x 2M Plasma table build
    By MonoNeuron in forum DIY Plasma Build Logs
    Replies: 14
    Last Post: 01-09-2009, 11:11 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules