Thread milling shallow bind hole

[suesi34e]

Hello Komatias,
Thank you for your reply. I realize I am not on the direct road for success, with the following
small diameter, shallow blind hole, in 316 no less, limited knowledge and wanting to thread mill it. All that said I may have a go at it.
Thanks
Steve

[komatias]

Hello Komatias,
Thank you for your reply. I realize I am not on the direct road for success, with the following
small diameter, shallow blind hole, in 316 no less, limited knowledge and wanting to thread mill it. All that said I may have a go at it.
Thanks
Steve

Cool! Was just adding an alternative to the mix with the ground taps. I will be doing some thread milling this weekend but on aluminimu pipe with fine threads M18x1 for my brothers project. Will post findings

[suesi34e]

Best of luck with that mate. Who know if my findings from my efforts are not too shameful I may post them! After this little job I hope to start a small router build!