Denford ORAC lathe spindle nose upgrade

[Chaz]

60mm Brass no problem...
140mm Alu, it depend... Is it a long piece or more like a disk ?
If you don't need the carriage to get under then you good for up to 200mm. otherwise, you are limited to 110mm roughly.

RNR

Disk, think of something like a wheel rim (scale RC).

[rnr107]

Disk, think of something like a wheel rim (scale RC).

In that case, no problem... I believe the ORAC would be fine for you...

Where are you based? Any close to Leeds / Bradford West Yorkshire?
If you want you can come to my place and see by yourself...

RNR

[Chaz]

In that case, no problem... I believe the ORAC would be fine for you...

Where are you based? Any close to Leeds / Bradford West Yorkshire?
If you want you can come to my place and see by yourself...

RNR

Thanks. Used to live in Whitworth, just North of Rochdale but now in West London area. Thanks for the offer.

[uli12us]

IIRC, in a recent Issue of MEW was the changing of the orac control to a newer one described. I hope, I can find the right one.