Meanwell SP-200-24 8.4a Power Supplies CHEAP!

[nirmal]

Oh bu**er. I just went and bought one for a higher price from aliexpress a few days back and I now have to wait a month for it to arrive.

[Clive S]

Oh bu**er. I just went and bought one for a higher price from aliexpress a few days back and I now have to wait a month for it to arrive.

If you are going to use this with your nema 23 motors and am882 drives then you will not get the best from them. 60-70V would be better.

[nirmal]

I've ordered a 60V 10A Mean Well for powering the motors. I also bought a separate 24V 3.2A power supply for powering the motion control unit (DDCSV1.1). It requires 18-32V >0.5A. I am thinking of using it to power a little 24V brush-less dc submersible pump for spindle cooling also.

[Lee Roberts]

Oh bu**er. I just went and bought one for a higher price from aliexpress a few days back and I now have to wait a month for it to arrive.

Damn it sorry about that!

This 24v one is the best price I could find vs form factor, it's only a 2amp rating power supply so it depends if you want to run other stuff from it, the problem/issue (for me at least) was that as you start going up in amps, the size of the unit gets bigger.

DC 12V/24V/5V Universal Regulated Switching Power Supply for LED Strip CCTV Hot

Link: http://m.ebay.co.uk/itm/222029680440

There is plenty of other sellers on there, the best prices seem to be coming from the sellers advertising these switch mode psu's as l.e.d driver units, there's quite a range to choose from once you start looking.

Just a note to anyone reading: Ideally you want a linear power supply to power your motors/drivers really, switch mode units do work though.

.Me